EN
36
ASSEMBLY
FITTING THE WHEELS
1. Carefully turn the charger over.
2. Align the support to the three holes underneath. Screw on the support with a Phillips screwdriver.
3. Put a lock ring on the axle with snap pliers. NOTE: Make sure the lock ring ts properly in the slot.
4. Put a wheel on the axle and then put on another lock ring.
5. Insert the axle through the casing.
6. Put on a lock ring, the other wheel and the last lock ring.
7. Press on the hubs in the middle of the wheels.
1. Axle x 1
2. Screw x 3
3. Lock rings x 4
4. Hub x 2
5. Wheel x 2
6. Support x 1
To Next Page
Loading...