EN
41
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The charger is switched on, but
the voltage status lamp does
not go on (before use).
The fuse has tripped. Insert a new fuse of the same
type.
The charger is switched on, but
the voltage status lamp does
not go on (during use).
The overheating protection has
tripped.
Switch o the charger
and allow it to cool. The
overheating protection resets
when the charger has cooled.
The voltage status lamp lights
up, but there is no charging
current.
The overload protection has
tripped.
Replace the fuse on the front
panel and check the polarity of
the connections.
MAINTENANCE
• Wipe the charger every time it has been used.
• Store the charger in a dry and clean place, out of the reach of children.
To Previous Page
Loading...