ELEKTRA 2500 HAMTRONIX
12
25 – SIMPLEX REPEATER (Default = 0)
Does not require separate receiver and transmitter. Even an HT can be used for this. When enabled, any incoming
signal will be recorded and played back. The duration of each transmission should not exceed 20s or it will be
cropped. Due to its low cost, simplex repeater mode can be invaluable for emergency and expedition purposes.
2 Enable with courtesy tone
Note: As use the space for voice message ID, all prior contents will be lost. Function 38 must be disabled in order
to use this function.
26 – REPEATER TIME-OUT (Default = 6)
Determines the maximum allowed time for each transmission. 10 seconds before the time is up, a short beep will
indicate that the time-out time has almost been reached. After time-out, a melody will be heard, and the transmitter
may or may not drop depending on the setting of function 09. If dropped, will remain that way until the COR that
caused the time-out is dropped.
Note: The timer counter is reset at courtesy tone. If the signal that caused the time-out drop is still on the receiver
holding the transmitter keyed, you can send * to bring it back (your signal must be stronger in order to gain control).
27 to 32 – REMOTE OUTPUTS 1 to 6 (Default = 0)
6 remote outputs are available for general purpose use.
2 Pulse (inverts state for 100ms)
Example: To enable output 5 press: 1234311#
Note: These outputs are CMOS logic and can drive a maximum of 10mA each. If you need to interface with a relay,
use a transistor as a buffer. In model 2500CT, this output should not be used if build-in CTCSS decoder is being
used. Changing remote outputs will cause CTCSS frequency to change randomly.
33 – REPEATER DTMF CONTROL ENABLE (Default = 1)
You can disable the repeater port from accepting DTMF commands when the link port is up, and you can control it
by another frequency on the link port.
Note: You can’t enable this function if the link port is down.
34 - DTMF MUTE ENABLE (Default = 0)
When enabled, anytime a DTMF tone is received, the audio will be muted to the Repeater's transmitter. The transmit
audio will remain muted for 2s after the last DTMF tone is received. This feature prevents control commands from
being repeated. It provides an extra measure of security. There may be times when it is desirable to pass the DTMF
tones through the repeater and you can disable this function.
Note: Do not use excessive levels at RX-1 trim pot because saturated audio with high tone voices may fool the
DTMF decoder and cause an undesirable mute over a voice communication.
35 – PASSWORD SETUP (Default = 1234)
To change the password.
If the actual password is 1234 and you want 5678 press: 123435#56785678#
Note: The new password is entered twice for security purposes.
To Next Page
Loading...
Need help?
General