ELEKTRA 2500 HAMTRONIX
10
14 – ID TIMER (Default = 1)
Determine how often the ID (voice or CW) will be transmitted.
Note: Option 08 is available for beacon or fox hunting applications in CW only. Prefer to use the 3s intervals for
sending commands to controller.
15 – ID SELECTION (Default = 0)
Determine which ID will be transmitted. Option 0 and 1 will be transmitted following the time programming on
function 14. Option 2 will not play the ID after the time is exceeded until someone keys up the repeater, when the
message 1 will be played. If the repeater is busy at the time of ID, message 2 will be played as soon as COR is lost.
Note: If the repeater is busy at the time of ID for option 1, the voice will give a place for CW ID. This behavior can
be changed with function 41. Option 2 will only be available if two messages are selected at function 40.
16 - CW ID FREQUENCY (Default=7)
Determine the CW ID Tone Frequency.
17 –CW ID SPEED (Default = 4)
Determine the speed for CW ID.
18 – CW ID SETUP
A maximum of 20 characters is available for CW ID message. See an example for programming the word “TEST” in
CW:
Enter: 123418#2005192005#
If the entered string is valid, you will hear the ok confirmation and the CW ID will play.
Note: If you make a mistake when entering the string, just press * to clear the string and start over.
CODES FOR CW PROGRAMMING
To Next Page
Loading...
Need help?
General