ELEKTRA 2500 HAMTRONIX
11
19 – VOICE ID MESSAGE RECORDING
The maximum recording time is 20s. If you choose Smart ID (function 15-2), this time will be split in two, resulting
in two 10s messages each. After sending the command, release PTT switch and the next key up will be recorded
and played back after recording. The voice ID time interval is the same as function 14.
Ex: To record a message press: 1234191#
Note: Don’t exceed the maximum time selected or the messages may become overlapped. Function 38 (Voice
Message Lock) must be disabled in order to record the voice message or you will get an error alert. Besides over
the air recording, you can use an external source of audio by using the K1 audio jack. Use the same commands as
you would by on the air recording, but when pressing the PTT, the external audio will be recorded instead.
20 – ALARM INPUT (Default = 0)
This alarm input is available for violation detection for windows, doors or repeater cabinet. Using any kind of detector
or sensor, a GND signal must be present all the time connected to alarm input (CN2-7) in order to not trigger the
alarm. If this ground signal is missing, the alarm will be triggered and stay in alarm until a command is sent to turn
it off. A siren sound will be transmitted over the air.
Note: Even with alarm activated the repeater will still be available for communication, but the siren sound will return
as soon as the communication ends.
21 – MONITOR INPUT (Default = 0)
A monitor input is available for lost AC voltage or logic state monitoring. When this input (CN2-8) is open or high
(5V), a short tone will precede the regular courtesy tone otherwise (low) nothing happens.
Note: Due to a pull-up resistor this input will be considered high if not connected.
22 – REPEATER PORT (Default = 1)
If disabled, the repeater will only accept signals coming from the link port.
Note: This function only can be disabled if link port is enabled.
23 - LINK PORT (Default = 0)
Signals from link port will be discarded
Allow access to repeater coming from another frequency (high priority)
Allow control access coming from another frequency (high priority)
Link operation (no hang time for signals coming through this port)
24 – TRANSMITTER TEST (Default = 0)
Note: This option has no time-out. Make sure your transmitter can stay keyed up for extended periods without
overheating. The tone frequency will be the same as simple courtesy tone (function 05)
To Next Page
Loading...
Need help?
General