Hanbell RTM-090 - 3.2 Vane Actuator Control and Settings

[文件標題] [日期]
13
Vol. 1.2 © 2020 Hanbell Precise Machinery Co., Ltd.
All rights reserved
Remark：1. IGV should be fully opened before start up. When HGBP opened before stop，please keep
IGV fully opened.
2. IGV operating range is 20%~100%.
3. Actuator signal feedback window:
Figure 3.2 OPEN Figure 3.3 SHUT
3.2 Vane actuator control
3.2.1 Actuator data
RATED POWER
1Phase, AC 220V±10%(50/60Hz)
1Phase, AC 110V±10%(50/60Hz)
INPUT SIGNAL
4~20mA‧DC；1~5V‧DC
OUTPUT SIGNAL
4~20mA‧DC
OUTPUT TORQUE
49N‧m(5kgf‧m)
OPERATION SPEED
15sec(50Hz)；12.5 sec(60Hz)
TRAVEL ANGLE 0~90°
RATED OPERATION TIME Continuous (100%)
RESOLUTION Over 1/250
DEAD ZONE Max. 0.5%
PROTECTION Motor thermal protector (120ºC)
AMBIENT TEMPERATURE Ambient temperature within: -25~55ºC
RATED CURRENT
0.4A(220V)；0.7A(110V)
MOTOR 20W
INSULATION GRADE Class E
INSULATION RESISTANCE Between power terminal – case : 500V·DC / 100MΩ
WITHSTAND VOLTAGE Between power terminal – case : 1500V·AC / 1 minute
WIRE INLET
G1/2×2
ENCLOSURE PROTECTION
NEMA-4X (IP-66)
WEIGHT
4.5kg
Table 3.1 Actuator data
Note：When operating at ambient temperature under 0℃, optional space heater is required to keep the
actuator inside dry. Otherwise, moisture may condense under low temperature and high humidity or
parts may shrink at low temperature.