EasyManua.ls Logo

Hangar 9 ARROW - Evolution Trainer Power System

Hangar 9 ARROW
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Evolution Trainer Power System
The Evolution Trainer Power System has been specifically designed
with the first time pilot in mind. The engine and special three
blade propeller have been designed to give your Arrow Trainer the
optimum performance for training new RC pilots. The engine is
designed for easy starting and reliable idle to give you confidence in
your equipment, allowing you to concentrate on developing your
piloting skills.
Benefits of the Evolution Trainer Power System
• Lower noise level than standard 10 x 6 prop, baffle in muffler
lowers noise even more
• Smaller speed envelope—the 3-bladed prop design has
a lower top speed, so overspeeding the model is less likely;
this gives the beginner more reaction time while still
providing lots of power to climb out of bad situations
• Pre-set needle settings—ready-to-run out of the box
• Needle valve limiters make it impossible for beginners to
adjust the needles valves wrong to the point that the engine
will not run
• User friendly—easy to start from first try with super reliable
idle and no break-in needed
Warning: Before operating your engine, read and
follow all safety points. A rotating propeller can cause
serious personal injury.
Follow these instructions carefully! If this is the first time you
have run a model airplane engine, we recommend that you seek
the help of an experienced modeler. Your local hobby shop can
put you in contact with the flying club in your area.
• Only use a “Start Stick” or electric starter to start the engine.
• Only make adjustments to the carburetor from behind the engine.
• Keep spectators at least 20 feet away and out of the path of a
rotating propeller
• Wear safety glasses and hand protection when operating
model engines. Do not permit any objects to touch a turning
propeller. Remain clear of the propeller plane of rotation.
• To stop the engine, cut off the fuel and air supply by moving
the throttle stick and trim lever down to close the carburetor.
Do not stop the propeller with your hand or other object.
• Inspect the propeller after each flight; discard any propeller
that has nicks, scratches or any other visible defect. Do not
repair, alter or in any way modify a propeller. Replacement
propellers are available through your local hobby retailer.
10
20 feet

Related product manuals