Hanna Instruments Edge HI 2020 - General Setup

Setup/Installation
12
Option Description Choices Default
Basic mode
(pH and EC)
Sound
If enabled, a short
audible tone is
produced for key
stroke or calibration
conrmation and
a longer tone for
wrong key.
On or O On Available
Temperature
Unit
Select degree
Celsius or Fahrenheit
scale for displayed
and logged
temperatures.
ºC or ºF ºC Available
LCD Contrast
Permits modication
of the display
contrast for various
lighting conditions.
1 to 8 3 Available
Flash Format*
Only seen when
log errors are
present.
Permits formatting
the ash drive.
On or O OFF Available
Message
Transition
User may choose
how messages are
displayed on third
LCD line of display.
Word scroll
messages or
letter scroll
messages
Letter scroll
messages
Available
Reset Cong
To Default
Press the MODIFY key and CFM (when prompted) to reset
parameters.
Available:
RESETS with
Basic Mode
OFF.
Instrument
Firmware/
Probe
Firmware
Displays rmware
version of meter.
Using the u
key switches to
Probe rmware (if
connected) and
diagnostic made for
troubleshooting.
View only
Current
rmware
version.
Available
Meter ID/
Meter SN/
Probe SN
User ID and Serial
Number of meter
and probe (if
connected). Use
u to change
between the three
parameters.
Meter ID is user
selectable
0000/ Serial
Number
Available
CSV le
separator
Used to separate
columns in the CSV
le..
Comma (,) or
Semicolon (;)
Comma Available
*Note: Options that are seen under special conditions only.
General
Setup
w ww . . co m
information@itm.com1.800.561.8187