Need help?Do you have a question about the Hanna Instruments HI 98703 and is the answer not in the manual?
General| Range (NTU) | 0.00 to 1000 NTU |
|---|---|
| Detector (NTU) | Silicon Photodiode |
| Power Supply (NTU) | 4 x 1.5V AA batteries |
| Type | Portable Turbidity Meter |
| Calibration Points | Not applicable |
| Power Supply | 9V Battery |
| Resolution (NTU) | 0.01 NTU (0.00 to 9.99 NTU); 0.1 NTU (10.0 to 99.9 NTU); 1 NTU (100 to 1000 NTU) |
| Accuracy (NTU) | ±2% of reading |
| Light Source (NTU) | LED |
| Method | Nephelometric |
| Auto Shut-Off | Yes |
| Environment | 0 to 50°C (32 to 122°F); max 95% RH non-condensing |
| Measurement Range (PPM) | Not applicable |
| Resolution (PPM) | Not applicable |
| Accuracy (PPM) | Not applicable |
| Light Source (PPM) | LED |
| Detector (PPM) | Not applicable |
| Power Supply (PPM) | Not applicable |
| Dimensions (PPM) | Not applicable |
Instructions for proper handling and care of sample cuvettes.
Steps for cleaning and preparing cuvettes before use.
Procedure for standard, regular turbidity measurements.
Method for taking rapid, sequential measurements.
Procedure for averaging multiple readings for stability.
Steps for performing a two-point calibration of the instrument.
Steps for performing a three-point calibration of the instrument.
Steps for performing a four-point calibration of the instrument.
Description and resolution of common calibration error messages.
List of error messages and their troubleshooting actions.
To Next Page