43
Date
The date and date format are set in this function.
Press Modify and set the date using the keypad.
Press Accept to save the date.
Press Format to change between the available date formats:
DD/MM/YYYY, MM/DD/YYYY, YYYY/MM/DD, YYYY‑MM‑DD,
MM‑DD‑YYYY, and DD‑MM‑YYYY. The default format is YYYY/MM/DD.
Auto Poweroff
The Auto Poweroff function is used to save battery life. After the set
time is elapsed, the meter will:
1. Automatically switch off, if in normal measurement mode. Press
On/Off to switch on again.
2. Enter a sleeping mode, if the continuous logging mode is
selected with a logging interval of at least 30 seconds. The “Auto Poweroff” message and the
Wake up softkey appear on the LCD; logging is not stopped. Press Wake up to reactivate the
display.
Available options are: Not used (disabled), 5, 10, 15, 20, 30 or 60 minutes.
Press Modify to select the desired time interval. The default value is “not used”.
Key Beep
If enabled, an acoustic signal sounds every time a key is pressed. A
checked box indicates this function has been enabled. The default
setting is disabled.
METER SETUP
To Next Page
Loading...
Need help?
General
