45
• The meter will require password confirmation. Retype the same password and press Accept to
confirm.
• The meter returns to the “Meter Setup” menu. The checkbox corresponding to the meter password
is checked.
To disable the password protection highlight “Meter Password” and press Modify, enter the password
and then press Disable. “No password” appears in the text box. Press Accept to confirm.
Meter ID
The Meter ID may be used to uniquely identify a meter/oper‑
ator. Press Modify and a text box appears. Use the keypad to
insert the desired alphanumeric ID and press Accept to store the
identification. A maximum of 14 characters can be used.
Language
The language used in the meter user interface can be changed.
The default language is English.
Please contact your local Hanna office for currently available
languages.
Restore Factory Settings
This function restores measurement settings to their original
factory values. This includes measurement units, coefficients,
other measurement configurations and all logged data. The factory
calibration for the sensor channels is not affected.
• Select the “Restore factory settings” and press Select.
• The meter will ask to confirm: press Yes to confirm or No to escape.
Probe ID
The probe can be labeled with an identification code: press Modify and a text box will be dis
played. Use the keypad to enter the desired alphanumeric code and then press Accept.
A maximum of 14 characters can be used.
PROBE SETUP
METER SETUP
To Next Page
Loading...
Need help?
General
