Hansa C27EU O&M Manual – OM-023 Revision A 16/10/19
© Hansa Chippers 2019
Move the engine throttle control to approximately half
throttle.
Insert the key and turn it to the start position and hold
until the engine has started. Allow the engine to warm up
for 1-2 minutes before engaging the rotor.
WARNING: Never run the starter motor for more
than 10 seconds at a time. Allow to cool for 1 minute
before attempting another start.
Gradually and slowly engage the rotor by winding the
engagement handle in the clock-wise direction until it
comes to a stop. This should be done slowly over a period
of 20 seconds to allow enough time for the cutting rotor
to pick up speed without stalling the engine.
Increase throttle to full for chipping (move the throttle lever to the left-most position).
Note: Engine must run at full throttle for the automatic feed and feed roller to operate. Refer to the ‘Automatic
Feed Control’ section on page 5 to set the automatic feed control to the desired setting.
To shut the machine down, move the throttle control
lever to the idle position (far-right position).
To Next Page
Loading...
