Hansa C27 - Tyre Pressure; Maintenance & service intervals

Hansa C27EU O&M Manual – OM-023 Revision A 16/10/19
© Hansa Chippers 2019
18
3. Remove M16 nuts and bolts bolting the bearing to the housing.
4. Remove and replace bearing.
5. When replacing the pulley ensure the rotor pulley is lined up to the engine pulley with a straight edge. Ensure the grub
screws are tightened evenly so the pulley is tightened evenly.
6. The gap between the end of the sensor and the sensing plate should be approximately 3 mm. Adjust the sensor
accordingly. If it is set further away, then the sensor may not work properly and therefore the AFC will not work.
Tyre Pressure
The recommended tyre pressure is 65 Psi.
Maintenance & service intervals
Maintenance interval - service hours
10 or
50 or
100
250
500 or
800
Yearly
As req.
Service
Daily
Weekly
Biannually
Engine oil change - initial change
Initial
Hydraulic oil filter - initial replacement
Initial
Belt tension – check
Initial
Engine oil level – check
•
Air cleaner element – clean
•
•
Bearings – grease
•
Engine engagement rod – grease
•
Outlet swivel – grease
•
Knives– check, sharpen or replace
•
•
Belt guarding – remove and clean chip build-up
•
•
Drive belts tension - check/adjust
•
Hydraulic pump belt tension - check/adjust
•
Engine oil & filter – change
•
Nuts & bolts – check torque
•
Tires & rims – check
•
Hydraulic system – check
•
Hydraulic oil filter - replace
•
Battery terminals - check
•
Engine fuel filter – replace
•
Outlet chute – remove & clean swivel
•
Feed roller tension springs - replace
•
•
Air cleaner element – replace
•
Hydraulic oil & filter – replace
•
Feed roller teeth – sharpen
•
•
Engine system
•
Battery – replace
•
Drive belts – replace
•
Hydraulic pump belt – replace
•
Knives – replace
•
Anvil – replace
•
Hazard labels – replace
•