Hanse 370 - 1.10.2. Changing the gas cylinder; 1.10.3. Operating the gas system

H A N S E 3 7 0
30
1.10.2. Changing the gas cylinder
Change the gas cylinder as follows:
 First, switch off all gas consumers.
 Switch off the engine and the generator.
Danger: Never smoke or use open fire when changing the cylinder.
 Shut the valve at the cylinder.
 Loosen the pressure reducer at the valve of the cylinder. Only use appropriate tools so that you
don’t damage the connection and the fitting.
 Detach the empty cylinder from the mounting and take the cylinder from the cylinder box.
 Insert the new cylinder in the mounting.
 Fasten the mounting to the cylinder.
 Check if the connector thread at the cylinder is damaged.
Danger: Cylinders with damaged threads may not be used. There is a
danger of leaking gas.
 Carefully place the union nut and screw it hand-tight.
 Screw the union nut tight with an appropriate tool.
 Check whether the connection is tight.
Danger: Never use grease at the cylinder connection or the valves.
1.10.3. Operating the gas system
The gas system must be operated with great care. You should therefore keep to the following
sequence:
 Check if the cooker valve is shut.
 Open the valve in the cylinder box.
 Open the valve in front of the cooker. It is inside the cabinet next to the stove.
 Open one of the burner valves, keep it pressed (safety pilot) and ignite the gas.
 Keep the valve pressed until the flame burns stably!
When turning off, keep to the following sequence:
 Shut the valve at the cylinder; the flame extinguishes.
 Then shut the valve in front of the cooker and the burner valve!