Basic Operation
HDG2000 Series Arbitrary Waveform Generator 18
Please follow the steps below to enable or disable sound:
1. Press<Utility> button, and press ENT button to go into System Settings, then choose “Sound
Settings”;
2. Push F1 to enable or disable beep.
3. Press F2 to exit.
Network Settings
The system can communicate with PC by Ethernet interface.
1. Press<Utility> button, and press ENT button to go into System Settings, then choose “Network
Settings”, press ENT button to open “Network Settings” interface;
2. Press F1 to change IP address, input right format IP values by using digital keypad in the front
panel.
4. Press F2 to change subnet mask, input right format subnet mask values by using digital keypad
in the front panel.
5. Press F3 to change gateway, enter right format gateway values by using digital keypad in the
front panel.
6. Press F4 to change MAC, enter right format MAC values using digital keypad in the front panel.
7. Press F5 to exit.
Note: Not all mode of the machine has Ethernet interface.
Time Date Setting
Please follow the steps to change time and date:
1. Press<Utility> button, and press ENT button to go into System Settings, then choose “Time and
date Settings”, press ENT button to open “Time and date Settings” interface;
3. Press F1 to change year.
4. Press F2 to change month.
5. Press F3 to change day.
6. Press F4 to change hour.
7. Press F5 to change minute.
8. Press F6 to enter page 2 of main menu, and press F1 to change second value.
9. Press F6 to enter page 2 of main menu, and press F2 to exit.
Reference Source Settings
The default is 10MHz internal source. For the synchronization among different devices, please
choose external 10MHz crystals as clock source.
Please follow the steps to change reference clock source:
1. Press<Utility> button, and press ENT button to go into System Settings, then choose “Clock
To Next Page
Loading...
Need help?
General
