User Manual 81
Chapter 11 Remote Control
HDG2000B can be controlled remotely through the following two methods.
User-defined programming
Users can program and control the instrument by using the SCPI (Standard Commands for
Programmable Instruments) commands. For more information about the commands and
programming, refer to the SCPI protocol manual.
Use PC software
Users can use the PC software to send commands to remotely control the instrument. You can
download the software from our official website.
HDG2000B only can communicate with PC through USB. This chapter will give a detailed
introduction of how to use software to control HDG2000B remotely through various interfaces.
Subjects in this chapter:
Install Keysight IO libraries suite
Remote Control via USB
To Next Page
Loading...
