Harbor Breeze 41107 - User Manual

Questions and Answers

D
Dwayne WangAug 4, 2025
Why is my Harbor Breeze 41107 excessively wobbling?
- L
  lmooreAug 4, 2025
  Excessive wobbling in your Harbor Breeze fan can be caused by several factors. Start by checking and tightening all screws that hold the fan blades to the blade arms and the blade arms to the motor. Also, the blades may be unbalanced; try switching one blade with a blade from the opposite side or use a blade balancing kit. Ensure the fan mounting is secure to the electrical outlet box. If the fan is too close to a vaulted ceiling, use a longer downrod or move the fan. Lastly, check the set screw on the motor housing yoke and tighten it until secure.
R
Ronald ChaseAug 11, 2025
What to do if Harbor Breeze 41107 lights are not working?
- V
  Valerie ClarkAug 11, 2025
  If your Harbor Breeze fan lights are not working but the fan is, first, check that the bulb(s) are installed correctly. Ensure that the male and female plugs in the light kit fitter are connected properly. Turn the power off and check all connections at the ceiling outlet box. Also, the total power of the lights might be exceeding 190 W; if so, replace the bulbs with lower-wattage bulbs.
K
Kimberly RobertsAug 27, 2025
What to do if my Harbor Breeze 41107 Fan is noisy?
- T
  Tyler ByrdAug 27, 2025
  If your Harbor Breeze fan is making noise, several things could be the cause. First, check and tighten all screws that hold the fan blades to the blade arms and the motor, as loose blades can cause noise. Inspect the blades for cracks and replace any cracked blade. Ensure you are not using a full range dimmer switch to control the fan speed, as the wall control may not be compatible with the fan. Confirm that the outlet box is securely attached to the building structure. Also, make sure the mounting bracket is secured to the outlet box and that the screws are tight.
J
Justin LopezSep 10, 2025
What to do if my Harbor Breeze 41107 Fan does not move?
- E
  Eric MyersSep 12, 2025
  If your Harbor Breeze fan isn't moving, there are a few things to check. First, make sure the reverse switch is fully engaged by firmly pushing it to either the left or right. Ensure the wall switch is turned on. Check if the power is on and the fuse (breaker) is not blown. Finally, turn the power off and check all wire connections at the ceiling outlet box for any faults.

Summary

Safety Information

Electrical and Clearance Safety

Ensures safe electrical connections, code compliance, and adequate installation clearance.

Component and Handling Warnings

Highlights warnings on mounting, sharp edges, dimmer use, and correct parts for safety.

Preparation and Tools Required

Initial Installation Procedures

Power Disconnection Protocol

Crucial step to disconnect power at circuit breakers and wall switch before installation.

Standard or Angled Mounting Instructions

Closemount Installation Guide

Wiring the Ceiling Fan

Wire Connection and Securing

Connect fan wires to house wiring using connectors, tape, and tuck into box.

Critical Wiring Safety Practices

Adhere to warnings on wire capacity, grounding, and ensuring no exposed wires.

Final Assembly and Securing

Canopy Alignment and Attachment

Align the canopy with mounting screws and rotate to attach; secure with bracket screws.

Blade and Blade Arm Installation

Light Kit and Bulb Installation

Operating Instructions

Reverse Switch Functionality

Care and Maintenance Guide

Troubleshooting Common Fan Issues

Fan Not Moving or Noisy Operation

Diagnoses causes and solutions for fan failure to move or excessive noise.

Resolving Excessive Fan Wobble

Addresses common causes and fixes for fan wobble and instability.

Troubleshooting Light Kit Issues

Harbor Breeze 41107 Specifications

General

Brand	Harbor Breeze
Model	41107
Type	Ceiling Fan
Number of Blades	5
Motor	AC Motor
Motor Speed	3 speeds
Reversible Motor	Yes
Light Kit Included	Yes
Control Type	Pull Chain
Finish	Brushed Nickel
Blade Pitch (Degrees)	12 degrees
Number of Bulbs	2
Bulb Type	Candelabra
Remote Control Included	No
Indoor/Outdoor	Indoor
Blade Span	52 inches
Mounting Options	Standard