11
Lowes.com/harborbreeze
Locate motor screws (N) and lock washers (O)
that were removed in Step 4 on page 7.
Insert two motor screws (N), along with 5.4 mm
lock washers (O), through one blade arm (J) to
attach blade arm (J) to motor. Tighten motor
screws (N) securely. Repeat with remaining
blade arms (J), making sure to completely secure
each blade arm (J) before proceeding with the
next.
3.
Remove three switch housing cap screws (U)
from top of light kit fitter (D).
If you wish to USE the light kit, remove finial (I),
finial plate (H), and rubber washer (T) from
bottom of light kit fitter (D). Save finial (I), finial
plate (H), and rubber washer (T) for later use.
Continue to Step 5.
If you do NOT wish to use the light kit, please
go to section titled “Installing Fan Without
Included Light Kit (Optional)” on page 14.
4.
FINAL INSTALLATION
3
4
U
T
D
J
Threaded
Rod
J
O
N
H
I
Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled FOR LIGHT and remove
plastic that holds these two wires together. Also,
remove molex safety caps from bottom of BLUE
(or BLACK) and WHITE wires. It may be
necessary to pull firmly in order to remove
molex safety caps.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter (D). Connect
BLUE (or BLACK) wire from switch housing to
BLACK wire from light kit fitter (D). Make sure
that molex connections are secure.
5.
5
D
Molex
Connections
Switch
Housing
Molex
Safety
Caps
U
Molex
Connections
To Next Page
Loading...
Need help?
General
