FINAL INSTALLATION
16
Align holes in light kit fitter (F) with holes in switch
housing. Make sure to align gap on edge of switch
housing cap (N) with reverse switch on switch
housing for the proper fit. Re-insert the light kit fitter
screws (S) that were removed at the beginning of
Step 5, Fig. 5A, on the previous page and use a
Phillips screwdriver (not included) to secure all light
kit fitter screws (S). (Fig. 7)
Switch
Housing
7.
F
7
Remove socket rings (L) from sockets on light kit
fitter (F). Attach glass shades (I) with these
same socket rings (L). (Fig. 8)
Note: Do not overtighten socket rings (L) as
glass may crack or break.
8.
J
9.
Install four candelabra-base 40-watt max. bulbs
(J) included. (Fig. 9)
Important: When you need to replace bulbs,
please allow bulb(s) and glass shade(s) to cool
down before touching them.
Note: This fan is equipped with a wattage limiting
device. Therefore, using a light kit other than the
one provided may cause the light kit to fail.
I
S
8
F
I
L
9
To Next Page
Loading...
