Hardi Commander Plus SPC Series - Turning Rim and Rim Plate; Permitted Rim Positions

16
GB 05 04 04
Sprayer setup
Permitted rim positions
IMPORTANT! Tyre sizes 18.4 x 38 and 20.8 x 38
are not permitted in any + position, only use the
- positions.
WARNING! When altering track gauge by turning
rims and rim plates the maximum permitted offset
between centre wheel and hub flange must be
observed:
&200$1'(5PRGH O 0LQULPRIIVH W 0D[  ULPRIIVHW
2200/2800  
3200/4200  
TT
TT
T
urning rim and rim plaurning rim and rim pla
urning rim and rim plaurning rim and rim pla
urning rim and rim pla
tete
tete
te
Max offset, hub flange and centre rim:
Track gauge can be altered by turning rim and rim plate,
positions refered to as + or - position.
Overview
T251-0020
hub
rim plate
T251-0003
T251-0004