58
GB 14 02 01
Maintenance
2
3
4
5
1
7
6
8
9
T180-0003
4. Nozzle f4. Nozzle f
4. Nozzle f4. Nozzle f
4. Nozzle f
ilterilter
ilterilter
ilter
ss
ss
s
Check and clean.
5. Spr5. Spr
5. Spr5. Spr
5. Spr
aa
aa
a
ying cirying cir
ying cirying cir
ying cir
cuitcuit
cuitcuit
cuit
Fill with clean water, operate all functions and check for
leaks using higher spray pressure than normal. Check
nozzle spray patterns visually using clean water.
6. Br6. Br
6. Br6. Br
6. Br
akak
akak
ak
es Air tankes Air tank
es Air tankes Air tank
es Air tank
Drain the air tank for condensed water at the drain valve.
7. Br7. Br
7. Br7. Br
7. Br
akak
akak
ak
eses
eses
es
Apply brake pedal and check function of trailer brakes.
8. R8. R
8. R8. R
8. R
etighten bolts (suspension only)etighten bolts (suspension only)
etighten bolts (suspension only)etighten bolts (suspension only)
etighten bolts (suspension only)
Check that these 9 bolts - on each side of the COM-
MANDER - are tight. Retighten if necessary. Tightening
torque:
Bolt 1 = 24 Nm (retain nut on the backside of the
mounting by a spanner while adjusting bolt 1).
Bolt 2-9: 280 Nm
Bolt 8 and 9 are situated behind the spring.
T180-0004T180-0005
T180-0006
T191-0001
T091-0004
10 hour 10 hour
10 hour 10 hour
10 hour
s sers ser
s sers ser
s ser
vicevice
vicevice
vice
1. Suction f1. Suction f
1. Suction f1. Suction f
1. Suction f
ilterilter
ilterilter
ilter
To service the suction filter:
1. Pull out the steel clip A.
2. Lift the suction hose fitting
B from housing.
3. Filter guide and filter C
can now be removed.
To reassemble:
4. Press the guide onto filter end.
5. Place the filter into housing
with guide facing up.
6. Ensure the O-ring D on the
hose fitting is in good
condition and lubricated.
7. Refit the suction hose B
and steel clip A.
2. Self-Cleaning F2. Self-Cleaning F
2. Self-Cleaning F2. Self-Cleaning F
2. Self-Cleaning F
ilterilter
ilterilter
ilter
1. Unscrew nut A and open filter.
2. Check filter gauze B, clean if necessary
3. Lubricate O-ring C
4. Assemble filter again.
3. In-Line f3. In-Line f
3. In-Line f3. In-Line f
3. In-Line f
ilter (ifilter (if
ilter (ifilter (if
ilter (if
f f
f f
f
itted)itted)
itted)itted)
itted)
If the boom is equipped with In-Line Filters
unscrew the filter bowl to inspect and clean the
filter.
Alternative filters are available. See section on
Technical specifications - Filters and nozzles.
To Next Page
Loading...
Need help?
General
