Harman AKG DHT800 - BACK and DSP Button Functions

controls on the receiver
DMS800 MANUAL
89
AUDIO menu Select the receiver channel CH1 or
CH2 in the submenus GAIN, DSP and
ATTENUATION PAD.
REHEARSAL menu Scroll through the HF level
9.2 Functions of the CH1, CH2 (10, 12) buttons
9.2.1 Functions in LOCK mode
In the main window Channel window for parameter overview, no
changes possible
9.2.2 Functions in SETUP mode
In the main window Channel window for parameter setting, no
changes possible
9.3 Functions of the BACK button (4)
Tap Close current menu
Allunconrmedvaluesaredeleted
Long press Close all menus
Allunconrmedvaluesaredeleted
The main window is displayed
9.4 Functions of the DSP button (2)
The factory settings of the DSP button can be found in section “16.1 DSP
proles:Factorysettings”onpage114.
In the main window Deactivate the LOW CUT, EQ, COMPRESSOR
and LIMITER functions for the corresponding
channel
In the AUDIO submenu Set the parameters of the digital signal
processor
CH1, CH2
buttons
BACK‑Taste
DSP button