Harman AMX DVX Series - Page 116

111
NO Command Syntax Example
79 AUDOUT_RESET_EQ
Command:
SEND_COMMAND <DEV>,
"'AUDOUT_RESET_EQ'"
Return:
AUDOUT_RESET_EQ
Description:
Resets all EQ levels to 0 for the audio
port addressed by the D:P:S. You can
optionally reset the EQ
for an audio output
Command:
SEND_COMMAND
AUDIO_OUTPUT_1,
“’AUDOUT_RESET_EQ’”
Return:
AUDOUT_RESET_EQ
80 AUDOUT_STEREO
Command:
SEND_COMMAND <DEV>,
"'AUDOUT_STEREO-<ENABLE|DISAB
LE>'"
Return:
AUDOUT_STEREO-<ENABLE|DISABL
E>
Description:
Enables or disables audio amp
output in stereo.
Command:
SEND_COMMAND
AUDIO_OUTPUT_1,
“’AUDOUT_STEREO-DISA
BLE’”
Return:
AUDOUT_STEREO-DISABLE
81 ?AUDOUT_STEREO
Command:
SEND_COMMAND <DEV>,
"'?AUDOUT_STEREO"
Return:
AUDOUT_STEREO-<ENABLE|DISABL
E>
Description:
Device responds with
"'AUDOUT_STEREO-<setting>'"
where setting is "ENABLE" or
"DISABLE".
Command:
SEND_COMMAND
AUDIO_OUTPUT_1,
“’?AUDOUT_STEREO’”
Return:
AUDOUT_STEREO-DISABLE
82 AUDOUT_TESTTONE
Command:
SEND_COMMAND <DEV>,
"'AUDOUT_TESTTONE-<frequency>
'"
Return:
AUDOUT_TESTTONE-<frequency>
Command:
SEND_COMMAND
AUDIO_OUTPUT_1,
“’AUDOUT_TESTTONE-off
’”
Return:
AUDOUT_TESTTONE-off