Harman AMX DVX Series - Page 131

126
NO Command Syntax Example
126 ANALOGOUT_AUDIO
Command:
SEND_COMMAND <DEV>,
"'ANALOGOUT_AUDIO-<OFF|INPUT
PASS-THRU|GROUP 1|GROUP
2|GROUP 3|GROUP 4>'"
Return:
ANALOGOUT_AUDIO-<OFF|GROUP
1|GROUP 2|GROUP 3|GROUP 4>
Description:
Determines which audio output the
analog audio output port addressed
by the D:P:S will use.
port={1-3}
Command:
SEND_COMMAND
AUDIO_OUTPUT_1,
“’ANALOGOUT_AUDIO-O
FF’”
Return:
ANALOGOUT_AUDIO-OFF
127 ?ANALOGOUT_AUDIO
Command:
SEND_COMMAND <DEV>,
"'?ANALOGOUT_AUDIO"
Return:
ANALOGOUT_AUDIO-<OFF||GROUP
1|GROUP 2|GROUP 3|GROUP 4>
Description:
Requests which audio output is
currently followed by the analog
audio output port addressed by the
D:P:S.
port={1-3}
Command:
SEND_COMMAND
AUDIO_OUTPUT_1,
“’?ANALOGOUT_AUDIO”
Return:
ANALOGOUT_AUDIO-OFF
128 XPOINT
Command:
SEND_COMMAND <DEV>,
"'XPOINT-<value>,<input>,<output
>'"
Return:
XPOINT-<value>,<input>,<output>
Description:
Sets the mode for the equalizer for
the audio port addressed by the
D:P:S.
Variables:
value = {-100-0}
input={1-15}
output={1-4}
Command:
SEND_COMMAND
AUDIO_OUTPUT_1,
“’XPOINT-0,1,1’”
Return:
XPOINT-0,1,1