Harman AMX DVX Series - Page 133

128
NO Command Syntax Example
System SEND_COMMANDs
1 ?FAN_SPEED
Command:
SEND_COMMAND <DEV>,
“’?FAN_SPEED’”
Return:
FAN_SPEED-<value1,value2>
Description:
Requests the speed of the fans
inside the unit.
2 ?TEMP
Command:
SEND_COMMAND <DEV>,
“‘?TEMP’”
Return:
TEMP-<value1,value2,value3>
Description:
Requests the temperature detected
inside the switcher.
3 ?AMPTEMP
Command:
SEND_COMMAND <DEV>,
“’?AMPTEMP’”
Return:
AMPTEMP-[value1,value2]
Description:
Requests the temperature detected
on the power amplifier board
Command:
SEND_COMMAND
SWITCHER,
“’?AMPTEMP’”
Return:
AMPTEMP-[39,39]
4 INTENSITY_LCD
Command:
SEND_COMMAND <DEV>,
“’INTENSITY_LCD-Value’”
Return:
INTENSITY_LCD-Value
Description:
Sets the intensity of the
lighting/brightness of the LCD
screen that is part of the Front Panel.
Variables:
Value{0-100}