Using the MX400
15
When finished, store the changes to the program if you would like them to be recalled.
chanGInG knoB aSSIGnMentS
The three parameters that appear for editing from the Program Screen in Surround
and Stereo Configuration programs are user selectable. From the factory, these param-
eters were selected in each program by their importance to the effect. If you would
like to access other parameters for each effect from the Program screen, you can select
these in the Knobs Assign menu. These assignments are individual to each program so
you can customize specific parameters for each effect depending on the program.
1. While on the Program Screen, press the Page/Select knob. This will enter the
Program Edit menus.
2. Turn the Page/Select knob until the Knobs Assign menu is highlighted. Edit/
Mix Routing is selected in our example.
3. Press the Page/Select knob to enter the Knobs Assign menu.
4. Turn either the A, B, or C knobs to select which parameter you want available for
editing from the Program Screen.
When finished, store the changes to the program if you would like them to be recalled.
effect MIX/routInG
Each of the MX400 programs offers programmable effect routing and a wet/dry mix
parameter for each effect. These different routings and mix controls give you many
options for your effect signal path and precise control over balance between the two
effects. In Dual Stereo Configuration programs, Effects 1 and 2 are used by Program A
(the program shown in the top half of the Program Display), while Effects 3 and 4 are
used by Program B (the program shown in the bottom half of the Program Display).
Routings for all configurations are as follows:
MX400
To Next Page
Loading...
Need help?
General
