17Features and Specifications Back Panel
NSG Output Ports
RF Ports
The NSG back panel has up to eight RF ports, numbered 1–8. Each port
outputs two channels.
Use RG-6 coaxial cables cable with F-type connectors to connect the RF
ports to the output devices. See“Connecting the QAM-RF Output Cables”
on page 21 for more information.
The following table provides the RF port specifications:
ASI Output Port for Monitoring
The NSG duplicates one transport stream to one ASI output port
designed for monitoring purposes, applicable to both ASI and GbE data.
Use this port to connect to devices that accept ASI input, such as an
MPEG analyzer.
What’s Next...
The next step is to unpack and cable the NSG, as described in the
following chapter.
Parameter Description
Connector Male F connector
Cable RG-6
Output frequency 53-868 MHz
To Next Page
Loading...
