35Cabling and Configuration Preliminary Configuration of the NSG
Configuring Date and Time
You may set the date and time for the NSG using the control panel. The
date and time are used in the generated reports.
To change date and time:
Once you are in Config mode, do the following:
1. Navigate to the Setup screen and click <Enter>.
The Config Operation Mode screen appears.
2. Click <Down or Up> to open the Unit Date/Time screen.
3. Click <Enter>. The Edit Date/Time screen appears.
4. To edit do the following:
Move the blinking cursor along the line, using the <Right & Left> keys.
When the blinking cursor is on the character to be edited, browse to
the required digit/month using the <Down or Up> keys.
5. To apply and to quit the editing mode, click <Enter >.
The Unit Date/Time screen appears with the newly updated date and
time.
Reset the NSG Unit
Via the control panel you may reset the NSG unit when required.
To reset the NSG unit:
Once your are in Config mode, do the following:
1. Navigate to the Reset NSG sub-screen of the Setup main screen.
2. Click <Enter> and follow the instructions on the display area.
Once boot up starts, the control panel displays the same messages as
during power up. (For further details, refer to Connecting Power.) If
BOOTP is enabled, an additional message appears indicating that the
NSG connects to the BOOTP server.
To Next Page
Loading...
