Harmonic NSG 9116 - Page 42

34 Preliminary Configuration of the NSG
CHAPTER 2
To set PHY configuration for ETH2:
Once you are in Config mode, do the following:
1. Navigate to the Network Config screen and click <Enter>.
2. Navigate to the Ethernet Port 2 screen.
3. Click <Enter>. The ETH2 IP Address screen appears.
4. Click <Down or Up> until the ETH2 PHY Config screen appears.
5. Click <Enter>. The Edit ETH2 PHY Config screen appears.
6. Using the <Down or Up> keys select the required option.
7. Click <Enter> to apply changes and to return to the ETH2 PHY Config
screen.
Setting BOOTP
You may select either of the following options for the ETH1 port:
■
Enable - select if you have BOOTP setup in your network and also
enter the required timeout. The required timeout is 10 seconds. If you
enter 0 the unit will continue to send BOOTP requests for an unlimited
time until it receives a reply.
■
Disable - the default option. Select this option if you do not have
BOOTP setup in your network.
To enable/disable BOOTP:
Once you are in Config mode, do the following:
1. Navigate to the Network Config screen and click <Enter>.
The Ethernet Port 1 screen appears.
2. Navigate to the ETH1 Port screen.
3. Click <Enter>. The ETH1 IP Address screen appears.
4. Click <Down or Up> until the ETH1 BOOTP screen appears.
5. Click <Enter>. The Edit BOOTP screen appears.
6. Using the <Up & Down> keys, select the required option.
7. Click <Enter> to apply changes and to return to the ETH1 BOOTP
screen.