Harris DA-DHR6802+ - Changing Parameter Settings; Recalling Default Parameter Settings; Reading the Software Version; Reading the Hardware Version

26 DA-DHR/DH/DSR/DS/HR/H6802+ Installation and Operation Manual
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Chapter 3: Operation
Changing Parameter Settings
You can change module parameter settings locally with the card-edge
jumper or remotely by selecting the Reclocking Mode parameter
setting.
Recalling Default Parameter Settings
You cannot recall default parameter settings for DA-DHR/DH/DSR/
DS/HR/H6802+ modules.
Reading the Software Version
The current software version of your pertinent module can be viewed
using Pilot (via Ethernet control). See your CCS Pilot User Manual or
Online Help for information on viewing software versions.
Reading the Hardware Version
The current hardware revision of your pertinent module can be viewed
using Pilot (via Ethernet control). See your CCS Pilot User Manual or
Online Help for information on viewing hardware identifiers.