MM-014763-001, Rev. E
69
11.2 SERIAL PROGRAMMING CABLES CA-013671-010 AND -020
Serial Programming Cable CA-013671-010 (10 feet long) or CA-013671-020 (20 feet long) can be used
to program and configure the M5300 mobile radio via a Personal Computer. Also, either cable can be
used to extend GPS NMEA-formatted serial data connections available at connector P5 of the radio’s
Options Cable. The cables’ assembly and wiring diagrams are shown in Figure 11-2 below.
The cable’
s male DB-9 connector (J1) mates to the female DB-9 serial port connector on the rear of the
radio. Alternately, if the cable is being used to carry GPS NMEA-formatted serial data from the radio, this
male DB-9 connector mates to connector P5 of M5300/M7300 Option Cable CA-012349-001.
The cable’s female DB-9 connector (J2) mates to a PC’s male DB-9 serial port connector. If the utilized
PC is not equipped with a DB-9 serial port connector, the use of a suitable adapter is required, such as
USB-to-RS-232 Adapter Cable CN24741-0001. As of the publication of this manual, CN24741-0001 is
available via the Customer Resource Center; refer to Section 3.3 on page 20 for contact information.
(Made From PS-CA-013671 Rev. -)
Figure 11-2: Serial Programming Cables CA-013671-010 and -020
To Next Page
Loading...
