Harris XL-185P User Manual

G1 SCBA Radio Pairing Guide | Harris
Rev. 5-23-2019
Page 10 of 13
Using the G1 SCBA and Harris XL-185P | XL-200P Radio
Confirm that the G1 SCBA, and Radio, are paired together: Radio Tag has been applied (or applied previously and pair is saved)
Step 1.
Turn on the Harris Radio using volume knob.
Step 2.
Don the G1 SCBA and G1 Facepiece.
Step 3.
Turn on the G1 SCBA via pressurization.
•
The G1 SCBA will try to establish a Bluetooth connection to the currently
paired radio for up to 8 minutes.
•
When found, it will quickly connect and disconnect, (and is now ready to
automatically activate when breathing.)
If the connection is not establis
hed, the pairing process described in the
previous section should be repeated.
Step 4.
Begin breathing (with the regulator attached) and the radio and SCBA will
connect automatically (approx. 20 seconds).
All SCBA voice communication will now go from the SCBA through the portable radio.
Use Notes & Tips:
• Turn on the Harris radio prior to the G1 SCBA.
• If the regulator is shut off, the G1 SCBA will not remain connected to the radio, and the radio is available for
non-Bluetooth use. The G1 SCBA will automatically re-connect to the Harris radio when breathing on the G1
regulator.
• Verify both the incoming and outgoing audio functionality after the Bluetooth wireless connection is established.
Using Paired
G1 & Radio

Harris XL-185P Specifications

General

Brand	Harris
Model	XL-185P
Category	Portable Radio
Language	English