Harris XL-185P - Adjust Audio and Microphone Settings

G1 SCBA Radio Pairing Guide | Harris
Rev. 5-23-2019
Page 3 of 13
Step 9.
The Personality will load into RPM2 in a new tab.
•
Save this Personality to the local computer (to write to other radios
later) by opening the “File” menu, and choosing “Save as…”
•
Use the “Save” Icon (or the File menu and “Save” item) to save your
changes to the personality.
Step 10.
(A) Click on the Personality’s “Options” Section to expand it.
(B) Choose the “Audio Settings” item.
Step 11.
Under “Audio Settings” > “Audio Menu Settings” and:
(A) Check “Speaker”
(B) “Noise Cancellation” OFF (unchecked)
In the “
PTT Options” of the same “Audio Menu Settings” section:
(C) Check “PTT”
(D) Select “Accessory Only”
I
f the Harris radio is equipped with a Harris FSM Speaker, the Rx audio will
always be
routed to BOTH the Harris FSM speaker AND the MSA G1 lapel
speaker
. If desired, the firefighter can turn off the G1 Lapel Speaker (in
order
to only play audio through the FSM speaker) by depressing the G1
Lapel Speaker
’s button for 3 seconds.
If the
Harris radio is NOT equipped with a Harris FSM speaker, the audio
will not play through the radio
speaker if the G1 Lapel Speaker is turned
off
; The G1 Lapel Speaker should be left ON in this situation.
Step 12.
Scroll down to “Bluetooth Microphone” options and:
Harris recommended settings are:
(A) Enable (check) “ALC”
(B) “ALC Max Gain” can be left at “6” (dB)
(C) Set “Mic Gain” to “8” (dB)
Consult your Harris radio technician before making adjustments to the
recommended settings.