Harvia REMOTE START system - 6 Commissioning

EN
Instructions for installation and use p. 11/15
6. Commissioning
To activate the remote start, refer to the installation instructions for the respective con-
trol unit. Once all cables have been connected, the remote start system can be used.
The devices (mobile phone and remote start system) must be part of the same
network.
● Open Play Store and install the app “Shelly Cloud”
● After opening, perform the following steps:
- Select language
- Create new user (account)
Conrmthegeneraltermsandconditions
- Enter your email address
- Set password
- Select “Create user account” (at rst installation)
or “I have an account”.
Aconrmationwillappearthatthishasfunctioned.
Nowloginwithyourpasswordandconrmthegeneraltermsandcondi-
tions once again.
Be careful when entering your email address when registering,
as this will be required if you forget your password.
In case you have forgotten your password, simply enter the email
address you used when you registered. You will then be given
instructions on how to change the password.
ATTENTION!!
Damage to the unit!
Before starting “6. Commissioning” and “7. Operation”, check that the units are
suppliedwithvoltage–however,thesaunacontrollermustbeswitchedo󰀨!