Harvia REMOTE START system - 5 Connection Diagram

EN
Installation instructions, only for experts p. 7/15
5. Connection diagram
Observe the following points when connecting the power to the sauna control unit:
● Connection work may only be performed when the power has been discon-
nected.
● Observe the assembly instructions for the respective control unit
black – K1, ST1 ...........
brown – L1, L3, L2 .......
grey – N .......................
red – S, X14 (remote start)
red – B, X15 (remote start)
Remove the pre-assembled cable lugs depending on the controller
used.
With 4 and 5:
● Polarity not relevant
1
2
3
4
5
ATTENTION!!
Damage to the unit!
The installation of the APP and the settings (see “6. Commissioning” and
“7. Operation”) must be completed before the sauna controller is switched on.