Need help?Do you have a question about the Haskris OPC3-OPC15 and is the answer not in the manual?
Details the number of refrigeration circuits and frame sections for each model.
Requirements for chiller placement, including foundation type and load.
Describes the chiller's vibration characteristics and isolation methods.
Guidance on locating chillers at different elevations relative to the application.
Specifies necessary airflow clearances for various chiller models.
Provides guidance on lifting, rigging, and transporting chiller units.
Guidance on selecting pipe sizes based on flow rate and length.
Covers piping materials, insulation, valves, and flushing procedures.
Details electrical connection compliance, wiring, and service disconnect requirements.
Explains phase monitor function and energizing the service power.
Steps to clean debris from piping before chiller startup.
Method to remove flush fluid and ensure a clean piping system.
Specifies glycol type, water type, and mixture percentage for freezing resistance.
Instructions for filling standard and sealed type reservoirs.
Steps to fill the piping with glycol mixture and remove air.
Verifies the phase monitor status for correct voltage and phase.
Ensures the controller displays no active alarms.
Details requirements for connecting the chiller to a BMS.
Information on available hardware, software, and specific unit capabilities.
Explains RS-485 and Ethernet connection points and wiring.
Procedure to align controller settings with BMS requirements.
Specifies supported baud rates for RS-485 communication.
How to interpret phase monitor indicators and resolve faults.
Instructions for using the rotary ON/OFF switch to control the chiller.
Procedure to fill the pump head with fluid for proper operation.
How to ensure adequate pump pressure by adjusting flow restriction.
Explains the components and data shown on the main display.
Describes the meaning of different status indicators on the controller.
Procedure to change the desired supply fluid temperature setting.
How to select and configure the display units for measurement.
How to detect, view, and understand fault descriptions and history.
Lists common faults, their explanations, and steps to resolve them.
Details the benefits of e-coated condensers for corrosion protection.
Explains chiller operation across a range of heat loads, including no-load.
Information on available potential free fault contacts on the controller.
Instructions for connecting and configuring remote ON/OFF functionality.
Details the remote panel's function, installation, and connectivity.
Describes the purpose and operation of redundant primary/standby pumps.
Explains the function of panels protecting condensers from hail damage.
Schedule for routine inspections and preventative maintenance.
How to check and maintain the glycol mixture level and quality.
Procedure for cleaning the wye strainer to maintain fluid flow.
Maintenance steps to remove dust and debris from condenser coils.
Guidance on performing electrical checks using a multimeter and phase monitor.
To Next Page
General
