1B20, 1B30, 1B40, 1B50 Safety
HATZ
17Manual
Maintenance work
Maintenance work that goes beyond the scope described in this manual
must only be performed by qualified technicians. We recommend that you
work with one of the over 500 HATZ service stations.
Replacing parts
▪ When replacing defective components, we recommend that you use gen-
uine HATZ original spare parts (see chapter 2 General information, page
6).
▪ When disposing of parts that can no longer be used, do so in accordance
with local environmental regulations or send them to a recycling center.
Measures following maintenance and troubleshooting
▪ Securely reconnect loose electrical connections; check that the electrical
components and equipment are functioning properly.
▪ Check the entire machine for foreign bodies; remove any foreign bodies.
Safety instructions for maintenance work
DANGER
Danger of explosion from flammable cleaning agents.
Cleaning with benzene is an explosion hazard. It is highly
flammable, can become electrostatically charged, and can gen-
erate an explosive gas/air mixture.
▪ Use halogen-free, cold cleaners with a high flashpoint for
cleaning.
▪ Comply with manufacturer's instructions.
WARNING
Danger of injury from compressed air and dust particles.
Eye injuries may occur when cleaning with compressed air.
▪ Wear safety goggles.
To Next Page
Loading...
