Safety 1B20, 1B30, 1B40, 1B50
8
HATZ
Manual
▪ Operation in an aggressive atmosphere (e.g. high salt content) without fur-
ther measures for corrosion protection.
▪ Installation of the device on movable supports (e.g. vehicles, trailers) with-
out HATZ approval.
▪ Improper operation at variance with DINISO3046 -1 and DINISO8528
(climate, load, safety).
Residual risks
Residual risks result during daily use and in association with maintenance
work.
These residual risks will be pointed out in chapter 3.2.2 Machine-specific
safety instructions for operation, page 15 and in chapter 3.2.3 Machine-
specific safety instructions for maintenance work, page 16 as well as in the
further contents of the manual, directly in front of the descriptions or operat-
ing instructions concerned.
3.1.2 Machine user or machine manufacturer obligations
Machine manufacturer obligations
If you have an engine that is not yet installed in a machine, it is imperative
that you follow the Assembly Instructions for HATZ Diesel Engines be-
fore installing the engine. These assembly instructions contain important in-
formation on how to safely install the engine and are available at your near-
est HATZ service station.
It is prohibited to start the engine before it is fully installed.
In addition, please note that it is prohibited to start up the machine before it
has been determined that the machine into which this engine is installed ful-
fills all safety-related requirements and legal regulations.
User obligations
The operator is obliged to only operate the machine when it is in perfect con-
dition. The operator must check the condition of the machine before use and
ensure that any defects are eliminated before it is taken into service. Run-
ning the machine while identified defects exist is not permitted. The user
must also ensure that all persons who work on the machine are familiar with
the contents of this manual.
To Next Page
Loading...
Need help?
General
