Maintenance 1B20, 1B30, 1B40, 1B50
66
HATZ
Manual
Step Activity Figure
6 Insert the oil filter and press it
all the way in.
7 Before tightening the screw,
ensure that the tension
springs(5) rest against the oil
filter at both ends.
Tighten the screw.
8 Check the oil level and add oil
to the max. mark if necessary
(see chapter 7.6 Check the oil
level, page 48).
8.2.6 Check and set the tappet clearance
Safety notes
CAUTION
Danger of burns.
There is a danger of burns when working on a hot engine. Only
perform the settings while the engine is cold (10-30°C).
▪ Let the engine cool.
CAUTION
Damage from inadequate engine cooling.
Only operate the engine when all covers are installed.
Preparations
The preparations are performed in different ways depending on how the en-
gine is equipped:
▪ Preparations on engine model with dry air filter
▪ Preparations on engine model with oil bath air filter
▪ Preparations on engine model for rammer operation (1B20 R)
To Next Page
Loading...
