Hatz 1B30 - 7.5 Switching off the engine; CAUTION; 7.5.1 Switching off the engine (mechanical)

Operation and use 1B20, 1B30, 1B40, 1B50
44
HATZ
Manual
Step Activity
3 Set the starting key to position "0".
4 Turn the starting key back to position "I".
The fault display lights up again.
Remedy the fault before making further starting attempts (see
chapter 9.1 Troubleshooting, page 87).
The indicator then goes out at the next start.
7.5 Switching off the engine
CAUTION
Danger of injury from unauthorized access.
There is a danger of injury if unauthorized persons handle the
machine.
▪ Protect the starting key against unauthorized access during
breaks in operation or after completing work.
CAUTION
Protect the ignition lock against dirt and moisture.
▪ With the starting key pulled out, seal the ignition lock with
the protective cap.
Methods of switching off the engine
The engine can be switched off in different ways depending on how it is
equipped:
▪ Speed control lever (mechanical)
▪ Stop pin (mechanical)
▪ Starting key (electrical)
7.5.1 Switching off the engine (mechanical)
NOTICE
i
Engines with a blocked lower idle speed cannot be switched off
with the speed control lever. In this case, the engine is switched
off with the stop pin or starting key, depending on how the en-
gine is equipped.