Hatz 1B30 - 7.3 Setting the speed control

1B20, 1B30, 1B40, 1B50 Operation and use
HATZ
37Manual
7.3 Setting the speed control
Safety note
CAUTION
Damage to the diesel engine due to inadequate lubrication.
▪ After the engine has been out of use for an extended period
(approx. 6 months or longer) or when the engine is first
taken into service, operate the engine at a low set speed
and without a load for approx. 20 seconds after starting.
This ensures good lubrication of all bearing points before
the speed and load are increased.
Overview
1 Speed control lever
Procedure
Step Activity
1 First move the speed control lever (1) to the "Stop" position.
2 Depending on the situation, place the speed control lever in ei-
ther the "1/2" or "Start" position.
NOTICE
i
A lower speed setting will cause less exhaust smoke when start-
ing.