1B20, 1B30, 1B40, 1B50 Safety
HATZ
19Manual
DANGER
Danger of explosion from flammable substances.
There is a danger of explosion from flammable gases.
▪ Keep batteries away from open flames and incendiary
sparks.
▪ Do not smoke when working with batteries.
CAUTION
Danger of chemical burns
Chemical burns can occur when using batteries for the electrical
operation.
▪ Protect your eyes, skin, and clothing from corrosive battery
acid.
▪ Immediately rinse areas affected by splashed acid with clear
water and consult a physician if necessary.
NOTICE
▪ We cannot be held liable for electrical equipment that is not
designed according to HATZ wiring diagrams.
▪ Promptly replace faulty indicator lamps.
▪ Do not pull out the starting key during operation.
▪ Do not disconnect the battery while the machine is running. Resulting volt-
age peaks could destroy the electronic components.
▪ When performing a manual emergency start, leave the (possibly depleted)
battery connected.
▪ When cleaning, do no spray the electrical equipment components with a
water jet or high pressure cleaner.
▪ When performing welding work on the machine, disconnect the battery
and place the ground clamp of the welding equipment as close as possible
to the welding area. Disconnect the plug-in connections to the voltage reg-
ulator.
▪ The following additionally applies before starting emergency operation
without the battery:
– In models with an instrument box on the engine, disconnect the
plug-in connection to the voltage regulator. Turn the starting key to
pos. "0" and remove.
– In models with an external instrument box, disconnect the plug-in
connection to the instrument box.
To Next Page
Loading...
