117 4001055180 E 06.21 USA / GB
General data
Pins and bearing inspection
MS0002
General data
Pins and bear ing inspection
1 - Warning
2 - Risk prevention
Means of protection to be used when implementing the range
3 - You will need
4 - Control and maintenance
Inspection of the pins, stop pins, bushings and bearings must be carried out according to the recommendations
Section D - Inspection and maintenance schedule :
• Fast visual inspection without disassembling Section D - Inspection and maintenance schedule :
• Check the presence of the pins and visible stops pins without disassembling.
• Check the presence of the screws.
• Check absence of deformations, cracks or breakage of pins and/or stops pins.
• Check absence of heavy abrasion, wear or oxidation of the pins, stops pins.
• Only an authorised and qualified technician is permitted to work on the machines HAULOTTE®.
• The use of this form implies that its user has been trained on this type of equipment.
• It is important that the person working on the machine is familiar with all of the safety information
contained in the user manual.
• Generally speaking, the user must comply with regulatory obligations in force, particularly those relating
specifically to working alone, co-activity and manual load handling...
• The user must have all the permits/authorizations required to work (fire permit, etc.) and comply with the
specific safety instructions at the intervention site.
• Only risks linked specifically to activities relating to the disassembly and assembly of the
machine HAULOTTE® are described in this sheet.
Appropriate workwear Gloves
Safety shoes
• Standard tool kit • Place barriers around the perimeter of the work area
To Next Page
Loading...
