137 4001055180 E 06.21 USA / GB
Chassis and turret
Overload system
MS0031
Chassis and turret
Overload system
1 - You will need
2 - Level of knowledge required
The use of this card implies that its user is trained on this kind of machine and that this training was delivered
by HAULOTTE® or an authorised representative, following the program for DIAG LEVEL II.
It is important that the person performing the work on the machine knows all the relative safety information contained
in the instruction manual.
3 - Safety instructions
• Standard tool kit
• Protective goggles
• Gloves
• Weight of 250 kg / 551 lb (for procedure reset 250 kg / 551 lb)
• Weight between 75 kg / 165 lb and 300 kg / 662 lb (for procedure
reset using variable weight)
• Lifting equipment adapted and suitable for placing and removing the
load from the platform
• Computer with HaulotteDiag and diagnostic kit ( 4000009300 ) or
DiagPad diagnostic console ( 400031760 )
• Place barriers around the perimeter of the work
area
Only an authorized and qualified technician can work on HAULOTTE® machines.
• The technician should take all steps to protect themselves or others against all risks of injury related to
this intervention.
• The technician should ensure that suitable PPE (personal protective equipment) for the job is used, and
check the particular conditions of environment in which the material can be found (see safety
information specific to the operation site).
• Position the machine on a flat ground, stabilized and in a released environment.
• Mark out the work area.
• Cut the contact, to remove the key, open the battery cut if fitted.
• Place a "DO NOT USE" decal near the start/stop contactor (key switch) to inform personnel that
interventions are currently underway on the equipment.
• The pressure in the hydraulic system is very important. It can cause accidents. Relieve the pressure
before any intervention and never search for oil leaks using your hands.
• Attention to the risks of burns, the hydraulic system works at high temperatures.
• The exhaust fumes of the engines contain harmful products of combustion. Only start and run the engine
in a well ventilated area. In a closed room, you must use a suitable system to evacuate the exhaust to
the outside.
To Next Page
Loading...
