144 4001055180 E 06.21 USA / GB
Chassis and turret
Overload system
MS0031
5.7 - FAULT CODES LINKED TO THE OVERLOAD SYSTEM
6 - Checks
Set a known weight in the cage and check the value displayed in Activ'Screen :
• Main menu > Diagnosis > Machine status > Overload(Strain gauge) > Estimated weight
Failures Description
Load management system
F06.01
No Loading Cal
Calibrate
No overload calibration, do/redo overload calibration.
Complete calibration.
F06.03
Gauges out of Range
SP800/SP801
Gauges out of range (load management system activated).
—> SP800 not in [1500; 20500] µA
Check SP800 connections to ground, to U104 ECU analogue inputs
Gauges out of range (load management system activated).
—> SP801 not in [1500; 20500] µA
Check SP801 connections to ground, to U104 ECU analogue inputs
F06.04
Incoh Gauges
SP800/SP801
SP800 measured weight and SP801 measured weight are more than 50 kg far (and gauges are not out of
range and gauges are calibrated)
Check SP800 and SP801 connections to ground, to U104 ECU analog inputs
Redo calibration
F06.05
Low Power
Gauges supply
Low power for strain gauges is detected low : VbattB2 basket is under 8500mV
Check gauges power supply
F06.09
Negative load
Negative load detected on SP800 gauge: measured load is below - 40kg and platform level angle is the
range [-10 ; +10]°
1.Check the platform does not lie on an obstacle
2.Check weighing system (adjustment), check measured load when platform is empty
3.Check the integrity of the structure.
Negative load detected on SP801 gauge: measured load is below - 40kg and platform level angle is the
range [-10 ; +10]°
4.Check the platform does not lie on an obstacle
5.Check weighing system (adjustment), check measured load when platform is empty
6.Check the integrity of the structure.
To Next Page
Loading...
