368 4001055180 E 06.21 USA / GB
Turntable
Checking and cleaning the fuel filter
MP0026
4 - You will need
5 - Procedure
• Position the machine on a flat and firm surface, clear of obstructions (beware of power lines).
• Put the machine in stowed position, boom and arm fully retracted and lowered.
• "DO NOT OPERATE" tag
• Personal protective equipment
• Standard tool kit
• Filter wrench
• Place barriers around the perimeter of the work area
1 person
• Check whether the water and dirt contained in the fuel has been
decanted into the water separator.
• If there are no impurities in the water: no action to be taken.
• If there are impurities or water in the bottom of the container :
• Set the handle of the separator to "OFF" (1).
• Loosen and remove the container ( 2 ) using a filter wrench ; Clean with
diesel.
• Clean the filtering part with diesel.
• Replace the filtering element with diesel protected from dust.
• Re-tighten the container ( 2 ) then reboot the system using the button at
the back of the engine ( 3 ).
• Release the air by loosening the screw, then re-tightening it (4).
To Next Page
Loading...
