6
1 Table of contents
1 Table of contents 6
2 Product information 7
3 Safety instructions 7
4 Abbreviations, symbols 10
5 Overviews 5.1 Overview: Left-hand system 12
5.2 Overview: Connector 55 (optional) 13
5.3 Overview: Connector 110 with and without base (optional) 14
5.4 Overview: Two inset pivot sliding doors 15
5.5 Overview: Position numbers 16
6 Planning 6.1 Planning: Inset doors 17
6.2 Planning: Guide for two pivot sliding doors 18
6.3 Planning: Doors closing against base and top section with Connector 55 19
6.4 Planning: Doors closing against base and top section with Connector 110 20
6.5 Planning: Doors in wall recess 21
7 Calculation 7.1 Calculation: Door size/height ratio 22
7.2 Calculation: Plan view dimensions 24
7.3 Calculation: Hardware depth 26
7.4 Calculation: Drill hole positions 27
8 Pre-assembly 8.1 Pre-assembly: Processing the left side profiles 29
8.2 Pre-assembly: Processing the right side profiles 30
8.3 Pre-assembly: Doors 31
8.4 Pre-assembly: Cabinet side 32
8.5 Pre-assembly: Outside pocket wall 34
8.6 Pre-assembly: Dampener 35
8.7 Pre-assembly: Upright 36
8.8 Pre-assembly: Aligning the cabinet 37
9 Assembly 9.1 Assembly: Scissor and upright, left-hand system 38
9.2 Assembly: Scissor and upright, right-hand system 41
9.3 Assembly: Doors 44
9.4 Assembly: Door closing system 46
9.5 Assembly: Fine adjustment of door upright angle 19 - 30 mm 48
9.6 Assembly: Fine adjustment of door upright angle 31 - 50 mm 49
9.7 Assembly: Positioning the stop dampener 50
9.8 Assembly: Door height adjustment 52
9.9 Assembly: Door clearance fine adjustment 53
9.10 Assembly: Front depth fine adjustment 54
9.11 Assembly: Fine adjustment of doors 55
9.12 Assembly: Fine adjustment pull-in speed 56
10 Disassembling 10.1 Disassembly: Door closing system for fixed outside panel 57
Contents
Page
To Next Page
Loading...
Need help?
General
