2. Hardware Installation
1. Unpack the HWPS1UG’s packaging and check all the items
listed in section 1.2.
2. Connect the HWPS1UG to the printer you want to share on
your network.
3. Connect the power adapter to the print server.
4. The print server will perform the Power-On-Self-Test
(POST) after it is powered on. The Status LED will flash for up
to one minute to indicate that the print server is ready.
NOTE1 : You MUST use the power adapter shipped with the HWPS1UG
print server, do NOT use any other power adapter from any other
sources.
NOTE2: To prevent any compatibility problems between the HWPS1UG
and other printers, it is recommend that you power on the print
server before the printer.
To Next Page
Loading...
Need help?
General
