To Next PageTo Next PageWhy Hayward Water Pump Motor Shuts OFF?
A frequent cause of your Hayward Water Pump motor shutting off is undersized wiring. Check for low voltage or power drop at the motor. To verify the electrical connections, it's recommended to contact a qualified professional.
How to fix a noisy Hayward Water Pump?
To address a noisy Hayward Water Pump: * Correct the suction condition or throttle return lines, if practical. * Mount the pump on a level surface and secure it to the equipment pad. * Clean the pump housing. * Replace all seal leaks at once.
What to do if Hayward Water Pump Motor Will NOT Start?
If your Hayward Water Pump motor won't start: * Ensure the terminal board connections match the wiring diagram on the pump data plate label. * Confirm the pump is wired for the available field supply voltage. * Inspect and correct any loose or improper wiring connections, open switches or relays, tripped circuit breakers, or blown fuses. * Manually check the motor shaft's rotation for free movement and absence of obstructions, and correct if needed.
Why Hayward Water Pump Motor Hums, But Does NOT Start?
If your Hayward Water Pump motor hums but doesn't start, it could be due to the impeller being jammed with debris. In this case, have a qualified repair professional open the pump and remove the debris.
How to improve low flow in Hayward Water Pump?
To address low flow in your Hayward Water Pump: * Correct the piping size. * Address a plugged or restricted discharge line of filter, or a partially closed valve. * For sand filters, backwash as per manufacturer’s instructions. For D.E. filters, backwash as per manufacturer’s instructions. For cartridge filters, clean or replace the cartridge. * Re-tighten the suction and discharge connections using PTFE tape and inspect other plumbing connections, tightening as required. * Replace the impeller, including a new seal assembly.
How to resolve interference with home automation equipment caused by Hayward Water Pump?
To resolve interference with home automation/power line communication equipment caused by your Hayward Water Pump: * Ensure the terminal board connections align with the wiring diagram on the pump data plate label. * Check for and correct any improper or loose wiring connections. * Install a noise filter (available from your home automation/power line communication equipment vendor) to prevent equipment interference.
What to check if Hayward System DC voltage is too high?
If the Hayward System DC voltage is too high, verify that the line voltage is within 10% of the pump's rated voltage at the terminal block.
What to check if Hayward System DC voltage is too low?
If the Hayward System DC voltage is too low, verify that the line voltage is within 10% of the pump's rated voltage at the terminal block. Also, verify that power supply connections are properly made at the circuit breaker as well as at the terminal block.
What to check if Hayward System Drive is overheated?
If the Hayward System Drive is overheated, check the motor airflow path for obstructions and clear them if present. Also, check the ambient temperature and verify it against the motor nameplate (50°C/122°F).
What to check if Hayward System Drive overload?
If there is a Hayward System Drive overload, check the impeller, diffuser, shaft seal, and motor for any issues or binding.
General| Model | HL32950VSP |
|---|---|
| Category | Lighting Equipment |
| Beam Angle | 120 degrees |
| IP Rating | IP68 |
| Lifespan | 50, 000 hours |
| Underwater Lighting | Yes |
| Voltage | 12V |
