4
Important information
HBM AED9301B
Important information
Neither the design of the device nor any technical safety aspects may be modified without the
express permission of Hottinger Baldwin Messtechnik GmbH. Any modification excludes Hot-
tinger Baldwin Messtechnik GmbH from any and all liability for any damage resulting there-
from.
It is strictly forbidden to carry out any repairs and soldering work on the motherboards or
to replace any components. Repairs may only be carried out by persons authorized
thereto by Hottinger Baldwin Messtechnik GmbH.
All the factory defaults are stored safe from power failure at the factory, not in the measuring
amplifier where they can be deleted or overwritten. They can be reset at any time by using the
command TDD0. For more information, see aed_help_e AD103C; “Description of the basic
commands”.
The production number is set at the factory and cannot be changed.
The transducer connection must always be assigned.
It is essential for a transducer or a bridge model to be connected up for operation.
To Next Page
Loading...
